SWM Contact Us | Home
Accessories  |  Aircraft  |  Boats  |  Cars  |  Helicopters  |  Engines  |  Radio  |  World Models  |  Enya  |  Latest News

Today on SWM
Steve Webb Models
Safe Internet Shopping
at ServoShop.co.uk

About Us


The Shop

Mail Order


Steve Webb
Exclusives & Specials
Click the Buy Link to buy on line
at ServoShop

The Wings Maker
EPO & Balsa Models

Wings Maker FC-1
6 Cell EDF

Ultimate EP
J10 Special
Show Edition

Sky Nova 2
Pre Assembled Combo

See E.P Ogar Kit EPO
Ogar EP BL Combo*

*Wing Bags Included

The World Models
Full Range

Multi Rotor
Quad Shop

Opti Fuel
Now In Stock
and also

Cool Power
Model Technics and Much More

Super-Micro DSMX/DSM2 1g Receiver with 2.5A ESC (Rx42D)


This is the Super Micro 1g DSMX/DSM2 Receiver with ESC.

How To Bind:

  1. Power up the receiver, the red LED light will blink slowly (approximately once every 0.5 seconds)
  2. Set the throttle and control surface failsafe protection (recommended to set the throttle to a minimum, all the control surface is set to the middle position). When the LED light on the Rx begins to blink rapidly, power on your Tx in Bind mode
  3. The LED light will turn off during binding, and when binding is complete will re-illuminate solidly, without blinking.
  4. To verify a successful bind, unplug the receiver from the power source, and power off transmitter. Re-power the transmitter and receiver and all channels should now be operating correctly. If not, restart the bind process from point 1.
  5. To test the failsafe protection feature, move the stick to the corner and turn off the transmitter. The control surface and throttle will return to the original position where the failsafe was set.


  • The correct procedure for powering up your models is transmitter power first, then model power.
  • Not suitable for conventional wide voltage servos.
  • Reverse power supply will damage the receiver.
  • When using a 1S battery, please use a low voltage micro servo.


  • Compatible with DSM2/DSMX transmitter.
  • Built-in 2A brushed ESC,supported external brushless ESC, no need to program.
  • The receiver signal can stay stable with a voltage as low as 2.5V.
  • Improve signal interruption problem when micro receiver using a conventional 1S brushless motor.


  • Channel: 4
  • Input Voltage: 3V - 5.5V
  • Weight: 1.4g
  • Dimension: 21.3x11.9x5.8mm
  • Servo Connector Size: JST 1.0mm

Recommended Parts for This receiver (Not Included):

  • Servo: 1.7g Servo with JST 1.0mm Plug, Click Here
  • Battery: 1S 3.7V 100mAh to 200 mAh LiPo Battery

More images


£19.99 Each

Buy online at
Privacy statement © SWM Limited 2021 Contact Us